Manual Jacking Legs/Steadies 29/45cm
Simple installation either through two mounting bolts on the top of the leg fixing bracket or via welding a bracket to the chassis/outrigger. The leg is held in a horizontal stowed position. To release, pull leg from locating notch and allow inner telescopic leg to extend by placing toe on release flange. Lock in place using tommy bar supplied. To release, apply pressure with toe on flange, then raise back to stowed position.
29cm - 45cm
Supplied as a pair
These units are solely designed to steady the vehicle (to avoid rocking when people are moving around in the vehicle), they're not designed or robust enough to use to lift the vehicle clear of the ground, like when changing a wheel.
Fixing centres are 75mm at 10mm diameter (well it was on the one I measured, but this may vary from the one supplied)
Please note, these are not robust enough to lift the vehicle clear of the ground, they're designed as steadies, not Jacks