_Mercedes Folding Handbrake kit with plastic covers
OEM folding handbrake kit which when set, folds back down to allow the seat to rotate.
Most owners chock their wheels and leave in gear so that the handbrake can be released to allow clearance to allow rotation of the driver seat.
This is only suitable for the newer Mercedes (Post 2006, however we have now fitted one to a pre 2006 Sprinter and found its best with some additional spaces - approx 5-8mm)
Delivery is usually 2-3 weeks as we don't hold this on the shelf, sorry.
We have fitted these to the TN1 pre 2006 Sprinter without big issues. The only issue, not that it was an issue, the TN1 handbrakes are held in place with two M8 bolts and the later vehicles used M10, so the holes are bigger than required. The handbrake cake sometime needs the slack taken up by adjusting the cable under the vehicle..
Please contact us before purchasing to check the price is correct due to the fluctuating exchange rates, sorry.
Some feedback we have received (relates to pre 2006 chassis)...
The clevis pin may need
changing (It may be too long, in which case a few washers will take
up the excess) please check.
M8 bolts of the
correct length, since the original ones are too short. Ideally
bushes should be used to take up the slack between the M8 bolt and
the M10 hole
The plastic covers may need trimming, especially if the rear floor
is higher than the cab floor